1·The formulas of shear strength and Young's tangent modulus taking account of temperature were proposed.
根据试验结果建立了考虑温度影响的非饱和土抗剪强度公式和切线杨氏模量公式。
2·The test results show that there is a linear relationship between confining pressures and initial tangent modulus.
试验发现，初始弹模与围压呈较好的线性关系。
3·The research results showed that specimens with higher temperatures showed higher shear strengths and Young's tangent modulus.
试验结果表明，随温度的升高，非饱和土的抗剪强度增加，初始切线杨氏模量增大。
4·The unloading deformation modulus can be expressed as the tangent modulus at any time; and it can be obtained through the test results.
任一时间的卸荷变形模量仍可表示为切线模量，并可通过试验成果推导得出；
5·Tangent modulus theory was introduced to determine the stability capacity of this new type of composite columns subjected to axial load.
钢骨-方钢管混凝土柱是一种组合柱设计模式，采用切线模量理论对该组合柱轴向受压稳定承载力进行分析。
6·In this paper, equivalent tangent modulus is introduced, Poisson ratio effect factor is obtained, Constitutive relation to be easy use in finite element analysis is founded.
本文引入等效切线模量，给出了泊松比影响因子，建立了在有限元分析中使用方便的本构关系。
7·As for the limit bearing capacity formula of the concrete filled steel tube long column subjected to axial compress, we lead to the tangent modulus and the conception of metal material.
在推导钢管混凝土轴心受压长柱临界承载力公式时，论文利用材料的切线模量，分别推导了钢材和混凝土的切线模量公式。
8·Based on the established relationship between the atomic potential and the macroscopic continuum strain energy density, analytical expressions for the tangent modulus tensors are derived.
利用原子间相互作用势以及能量等效原理，得到了基于广义连续介质模型的单壁碳纳米管的本构关系。
9·Drawing a tangent after inflection and intersected the abscissa the slope of the tangent was taken as the flexile modulus.
在不规则样条的负荷-挠度取拐点后直线段切线与横坐标的交点作零点修正后所测得的弯曲弹性模量比较接近真实值。
10·The bending stiffness of elastoplastic member is product of tangent elastic modulus of material and inertia moment of the section.
抗弯刚度的概念是材料切线模量和截面对中和轴的惯性矩的乘积。