1·Dynamically balanced 3 HP spindle motor.
显著均衡的3马力主轴电机。
2·It controls spindle motor rotation and heads movements.
它控制主轴马达转动和磁头运动。
3·Excess foam will hit the rear of the spindle motor causing damage to the board.
多余的泡沫会碰到转锭马达后面而损伤板材。
4·For the power in case of a power failure, back electromotive force of a spindle motor can be utilized.
对于在电源故障情况下的电力,可利用主轴电机的反电动势。
5·In this paper, a system for monitoring tool breakage by detecting the power of spindle motor is introduced.
本文介绍一种用检测主轴电机动率的方法来监测刀具破损的系统。
6·On floating. the gravity settlement centrifuge model for sure, completed the spindle motor and pump, hydraulic converter, special type of device, etc.
在对上悬式重力沉降离心机的型号进行确定后,完成了对主轴电机、变频器、液压泵、液压泵专用电机等器件的选型;
7·The spindle motor of the saw band wheels adopts stepless speed regulation, the movement of slides is driven by the servo motor, and the touch display is adopted.
锯带轮主轴电机采用变频调速,拖板移动为伺服电机,采用触摸式显示屏。
8·The design in this paper comes from a practical project of a spinnery. Our design and control object is the electrical spindle motor of weaving producing process.
本文的设计是来自于企业的一个实际的工程应用项目,设计控制对象为纺丝机电锭电机。
9·It analyzes the technique of extracting the spindle motor current of the Machining Center, correspondingly, points out that Hall current sensor is a very efficient way.
对自由曲面数控加工中主轴电机电流信号的提取技术进行了分析,指出了霍尔电流传感器是行之有效的方法。
10·By analyzing relation between BEMF of the hard disk spindle motor and the rotate speed. This paper presents a new method of following the motor rotate speed by PLL to lock BEMF.
通过对硬盘主轴马达的反电动势与马达转速之间关系的分析,提出一种利用马达的反电动势信号跟踪马达转动速度变化,产生系统伺服写入时钟信号的方法。