1·Mechanical properties of normalized Q460E could reach the requirement of some medium carbon quenched and tempered steel.
Q 460e钢正火可以达到某些中碳调质钢的力学性能要求。
2·This paper describes the application of high strength quenched and tempered steel in semi-submersible drilling platform.
阐述了超高强度的淬火回火钢（调制钢）在深海半潜式钻井平台中的应用。
3·Being compared with the normalized steel, the quenched and tempered steel can led to a joint with higher strength and toughness.
正火态与调质态母材相比，后者可得到强韧性较高的接头。
4·Low-alloy high strength quenched and tempered steel suggested using one-stage rolling method, cooling rate should not be too low.
低合金高强度调质钢建议采用一阶段的轧制方式，冷速不宜过低。
5·The evaluation of measuring uncertainty in metallic material Brinell hardness test is studied by testing the hardness of the 45 quenched and tempered steel.
以45#调质钢硬度试验为例，研究了金属材料布氏硬度试验中测量不确定度的评定。
6·Quenched and tempered steel after the tests have a high uniformity, as compared with the TMCP has superior strength and plasticity and strength and toughness.
调质后的试验钢有较高的均匀性，与TMCP相比，具有更优异的强塑性和强韧性。
7·The thermal fatigue crack propagated mainly through the break-age of the interface of carbide and grain boundaries for either quenched or quenched and tempered steel.
无论是淬火或淬回火态的试样其热疲劳裂纹主要沿着碳化物与基体脱开处及晶界裂纹桥接而扩展。
8·The quenched and tempered steel WH80Q offers high strength, excellent low temperature impact toughness, lamellar tearing resistance and lower aging sensitivity factor.
舞钢研制开发的调质钢wh80 Q具有高强度、良好的低温冲击韧性、抗层状撕裂性能、较低的时效敏感性系数。
9·Internal fatigue cracks occurred in the fracture of a quenched and tempered carburized steel specimen under tension-tension fatigue loads are discussed in this paper.
本文对淬火加回火渗碳钢的拉伸一拉伸疲劳断口进行了内裂纹的分析和研究。
10·The technology of traditional quenched and tempered medium carbon steel sliding yoke is very complicated and it has high rejection rate too.
传统的中碳钢调质处理滑动叉，工艺复杂、废品率高。