1·According to the elastic theory, this paper gives partition Law of stress and quantitative answers over the overlap joint weld on skirted support.
利用弹性理论，分析推证出了裙式支座搭接焊逢内的应力分布规律及其定量解答。
2·Varied types of intersecting joints, including gap joint with positive eccentricity for the circular tubes and overlap joint for the square tubes, were also adopted in the design.
设计中还采用了多种形式的相贯节点，包括圆管正偏心的间隙接头及方管的搭接接头。
3·The light-plate that is shot by semiconductor laser comes to a certain Angle to throw overlap joint, which brings a single vein of light, and CCD camcorder shoots and sends it to the computer.
半导体激光器发出的激光经过柱透镜形成一出射光片。它与母材成一定角度投射到接头上，光片与搭接接头会成一单光纹，而母材垂直上方的CCD摄像机拍摄折线光纹，同步送计算机处理。
4·In three overlapping circles, three round shapes overlap after the joint and overlap are preserved, only two circles overlap area have been cut off hollow out (figure 3).
以三个圆重叠来说，形状联合后没重叠部分和三个圆重叠部分被保留下来，只有两个圆重叠的区域被剪除镂空(图3)。
5·The gel hardens and the water dissolves, creating a strong joint where the single hair-fibres overlap.
凝胶硬化并且水溶解，形成单个毛发纤维重叠的牢固接头。
6·A joint blind estimation method based on spectrum overlap for uplink interleaved orthogonal frequency division multiple access carrier frequency offset and timing synchronization is proposed.
提出了一种基于功率谱叠加的交织正交频分多址系统上行链路载波频偏和定时同步联合估计算法。
7·An approach is first posed by using gnomonic projection, based on the problem remaining unresolved, which is about the coating joint modeling and the joint overlap of spherical equilateral polygon.
针对球面等边多边形包覆拼接建模及出现拼接重叠等问题，分析了心射球面投射原理和共球面等边多面体的结构特征，提出了共球面等边多面体作心射球面投射的方法。