1·The oil pan is usually formed of pressed steel.
油盘通常用的薄钢板冲压制成。
2·Loosen oil pan bolts and remove the front bolt at each side.
松动油底壳螺栓，拆下每一面的前螺栓。
3·The bottom of the block is covered with an oil pan or oil sump.
缸体的顶部是气缸盖，它组成了燃烧室，缸体底部是油底壳。
4·It also discusses some control methods for reducing the radiated noise from oil pan.
文中还论述了降低油底壳辐射噪声的控制方法。
5·This paper described two methods on how to predict the radiated noise of engine oil pan.
介绍了对发动机油底壳进行噪声预测的两种方法。
6·And this relationship is proved through the experimental investigation of 6105qa diesel oil pan.
通过对6105 QA柴油机油底壳的实验研究，证明这种关系是正确的。
7·If the way to remove oil pan oil change, you can put 70% of the oil, so as to ensure the transmission of health.
如果以拆卸油底壳的方式进行换油，则可以换上70%的油，这样才能确保变速箱的健康。
8·Therefore, in the winter comes, will be timely oil pan, air compressor in the oil into the oil used in the winter;
因而，在冬季降临时，应及时将油底壳、空气紧缩机内的机油换成冬季用的机油；
9·After the hot oil drops down into the oil pan, the oil gives up some of this heat to the air passing under the oil pan.
在热的机油流回油底壳后，机油将这些热量释放到流过油底壳的空气中。
10·Gaskets are also used to seal joints between other parts, such as between the oil pan, manifolds, or water pump and the Block.
密封垫也同样用于密封其它部件之间的接合处，例如，油底壳、歧管、水泵与气缸体之间的密封。