1·The no load speed decreases with the increase of surrounding temperature.
随着环境温度的增加马达的空载转速下降。
2·Plots the torque speed curve and power curves for given values of stall torque and no load speed.
绘制给定失速扭矩和空载速度时的力矩曲线和功率曲线，不含负荷转速。
3·The results show that stalling torque increases and no load speed decreases with the increase of the pre-load and degree of vacuum.
结果表明，随着预紧力和真空度的增加，马达的堵转力矩增加而空载转速下降；
4·No - load speed is one of important parameters in ultrasonic motors design.
无负载转速是电动机设计过程中的一个重要参数。
5·When the flux must be reduced, however, power must be applied just to lower the field so that PM motors at high speed need some current even at no load.
当流量必须减少，但是，权力必须适用只是降低外地，这样下午电机在高速需要一些目前，即使在无负载。
6·No beat or squeeze when connect load to the outer axis of gear speed reducer so that not to arise deformation and dislocation, bad noise or locked dead.
齿轮减速器的出轴与负载连接时不能重力敲打、挤压，以免造成内部变形走位，产生严重噪声或卡死现象。
7·Producing little stretch distortion and having no flection under permitted air speed and pressure are the criterions of assessing air conduit capacity based on its bearing load.
基于风管所承受的各种荷载来评定其工作能力，通常在允许的气流速度（或压力）下，是否只产生较小的弹性变形，而不产生屈曲。
8·After calculating no load gap magnetic fields according to different rotor positions, static torque characteristics and highest working speed are worked out.
计算了对应不同转子位置的空载气隙磁场分布，求出了静转矩特性和平衡头最高工作转速。
9·The insert bears no vehicle load until the tire is punctured, at which point the load is transferred to the insert and vehicle movement may continue for a limited distance and speed.
这些单元在平时的时候不承载车辆的重量，只有当轮胎被打破了才会担负起承载的重任，这时候车辆的重量会转移到这些单元上，它们能支撑车辆继续以一定的速度移动一段距离。
10·The rotary speed has no effect on the working load on cutting teeth.
转速对切削齿上的载荷分布基本无影响。