1·A new Ni-based filler metal is introduced.
介绍了一种新的镍基焊料的开发应用情况。
2·Interactions of laser beam with filler metal.
激光束与填充金属之间的相互作用。
3·Thicker filler metal led to bigger deformation.
钎料厚度较厚时钎焊变形较大。
4·The key to obtain a good bond is the ability of the filler metal to wet the YSZ.
的关键，取得了良好的债券的能力湿料的氧化锆。
5·The main defect in vacuum brazing Joints is that the filler metal does not penetrate…
真空钎焊缝中主要缺陷为未钎透，并对条状未钎透和网状未钎透进行了分析。
6·The quantity of filler metal being often much lower than with other welding processes.
低成本的焊道，与其他焊接过程相比，填充金属的数量相对比较少。
7·Spot welding procedure of copper with inlaid filler metal sheet HL204 is introduced, too.
介绍了铜与铜镶嵌片状钎料HL204点焊的工艺方法。
8·The results indicate that the crack is related to the chemical composition of the filler metal.
试验表明，焊接裂纹与填充材料的化学成分有一定的关系。
9·Excellent mechanical properties can be obtained by using YS800 welding wire as the filler metal.
与YS800焊丝配套的气体保护焊接头力学性能优异。
10·On average, metal-cored wires cost more per pound than other filler metals, particularly solid wire.
一般来讲，金属粉芯焊丝花费要高于常规焊材，尤其是实心焊丝。