1·Double eccentric shaft vibration exciter is the source of linear vibration.
振动给料机由双偏心轴激振器提供直线振动源。
2·Abrasive machining for eccentric shaft of rolling cut type sizing shear has been described in this paper.
介绍用磨削方式加工临钢滚切式定尺剪偏心轴的方法。
3·The succeed of rolling of eccentric shaft in front and back brake will expand the application of wedge rolling.
分析了前、后制动蹄偏心轴轧制的工艺设计,推导了偏心部分的孔型曲线方程,对零件轧制的工艺调试也作了简要分析。
4·One end of a paper transmission drum is provided with an eccentric shaft sleeve and a driving mechanism is at the lower part of the eccentric shaft sleeve.
在传纸滚筒一端上带有偏心轴套,偏心轴套下部有一驱动机构。
5·Main products are: Continental C Series jaw crusher machine and its components, a moving jaw, front plate, back plate, dental plates, side guard, jaw plate, eccentric shaft, flywheel, bearing, etc.
主营产品有:欧式C系列颚式破碎机整机及其部件,有动颚、前板、后板、牙板、边护板、颚板、偏心轴、 飞轮、 轴承座等;
6·Because an eccentric can be attached anywhere along a shaft, it is unnecessary to form any part of the shaft into a crank.
由于偏心轮可装于轴的任何部位,不必把主轴作成曲柄。
7·Shaft coupling: eccentric allow range can be flexibly applied in all kinds of transmission system.
偏心允许范围大,可灵活应用于各种传动系统。
8·In this paper the demands, the lowest mass design principle of balancer shaft of fan type and eccentric circle type balancer mass are analyzed.
分析了扇形和偏心圆两种平衡轴设计的要求以及平衡重低质量的设计原则。
9·The cross wedge rolling deformation process of shaft parts with eccentric section was simulated with three-dimension finite element soft LS-DYNA by using elastic-plastic finite element method.
利用三维弹塑性有限元软件L S- DY NA对一种典型偏心轴类零件楔横轧成形进行了数值模拟,分析了其成形过程、应力应变场分布及工艺特点。
10·At one end of the inner ring, the bearing is clamped to the shaft with an eccentric locking ring (Figure 1.7) or with two setscrews (Figure 1.8).
在内圈的一端,轴承通过偏心锁定环(图1.7)或者两个定位螺钉(图1.8)被固定在轴上。