1·Crystallization temperature rised with decreasing viscosity.
结晶温度随着粘度的降低而升高。
2·Crystallization temperature of the as-quenched alloys were measured by DSC.
用DSC法测定了制备态合金的晶化温度。
3·The results show that supercritical CO2 depresses the crystallization temperature of BAPC.
结果表明，超临界CO2显著降低BAPC的结晶温度；
4·The results show that the crystallization temperature decreases with the increase of cold pressure rate.
结果表明，随冷轧压加率的提高，再结晶温度降低。
5·It was further indicated that the apparent volume of CTCBE was decided by the crystallization temperature.
进一步表明CTCBE在自然缓冷固化的表观体积根本上由其结晶温度决定。
6·The results showed that optimized flux has higher crystallization temperature, lower viscosity and melting point.
结果表明：优化的保护渣具有较高结晶温度、较低的粘度和熔点；
7·The crystallization temperature and dielectric properties of PLZT thin films with PLT seeding layers were investigated.
研究了有晶种层的PLZT薄膜的结晶温度及介电性能。
8·It has been found that as the heating time increases, the crystallization temperature of the amorphous alloy will decrease.
该非晶合金出现晶化的温度随热处理时间的增长而降低。
9·The DSC results showed both the melting temperature and crystallization temperature of the grafting products were decreased.
DSC研究表明辐照接枝产物的熔融温度和结晶温度均降低。
10·With the steel line and the solid phase of the high and low liquidus temperature and crystallization temperature of the size of interval.
它们与钢的固相线和液相线温度的高低及结晶温度区间的大小有关。