1·It corresponds to the "jet wake" structure of centrifugal compressor.
这与有关文献中所指出的离心风机的“射流尾流”结构相对应。
2·This paper gives a method for drawing centrifugal compressor impeller by use of microcomputer.
本文给出了一种以微型计算机为工具绘制离心压气机叶轮图形的方法。
3·The operating condition of dry seal on centrifugal compressor and its economic benefits are introduced.
介绍了干气密封在离心压缩机上的工作运转情况,及其所带来的经济效益。
4·Critical speed is one of the important dynamic parameters of the rotor system in centrifugal compressor.
临界转速是离心压缩机转子系统的主要动力参数之一。
5·This paper puts forward a method for designing the backward swept blades for centrifugal compressor impellers.
本文介绍一种具有后掠叶片的径流式压气机叶轮造型方法。
6·A geometry designing method for developable surfaces backward swept centrifugal compressor was given in this paper.
给出一种可展曲面后掠叶片离心式压气机叶轮选型方法。
7·Glasfloss Z-Pak GT filters are ideally suited for the rigors of gas turbine and centrifugal compressor applications.
此款燃气轮机过滤器非常适合用于要求严格的燃气涡轮和离心式压缩机应用。
8·The presented problems and resulted harm about air seal axial clearance in a centrifugal compressor are pointed out.
指出了离心空压机气封轴向间隙存在的问题及造成的危害。
9·The calculating method of viscous end speed defective value & end width for centrifugal compressor impeller is given.
给出了离心压缩机叶轮粘性尾迹速度亏缺值及尾迹宽度的计算方法。
10·Coke oven gas is most hydrogen and methane gas is not pure, and, therefore, generally with the centrifugal compressor.
焦炉气大部分是氢和甲烷,气体不纯净,因此,一般用离心式压缩机。