1·Rinse surface with DI water.
用去离子水冲洗表面。
2·Clean with DI water and dry with compressed air.
用去离子水清洗，压缩空气吹干。
3·ABS piping is normally used in High Purity DI Water System.
ABS配管通常使用于高纯度的DI水系统。
4·Each Reactor will be equipped with DI water cooled electrodes.
每个反应器都配有电极，电极采用脱盐水进行冷却。
5·Rinse surfaces once through with DI water until conductivity of inlet and outlet fluids are within tolerances.
用去离子水单次使用冲洗表面直到入口和出口的液体的电导率在容许范围内。
6·In salt water the composites had less water absorption, absorption rate and diffusion coefficient than that in di water.
与在去离子水中相比，材料在盐水中饱和吸水率、初始时吸水速率和水扩散系数较小。
7·Three to five years large size foreign manufactory power supply, compressed air system, vacuum system & DI water system, management experience.
三到五年大型外资工厂电力，空压系统，真空系统、DI水维护管理经验。
8·Method 1 clean surface with aqueous cleaning solution, apply passivation paste to surface, rinse surface with DI water until traces of chemicals are removed.
方法1：用水清洁溶液清洁表面，向表面应用钝化剂，用去离子水冲洗表面直到全部除去化学试剂的痕迹。
9·Standard leaning chemicals can be add into machine manually or using dosing pump to add pure chemicals and DI water automatically according to different ratio(5%~20%).
可将浓度配比好的清洗液人工加入；也可按设定比例（5%~20%）自动配比DI水与浓缩清洗液（选配）。
10·After di water rinsing and before baking, a drain time of 5 minutes with an elevation change is recommended to remove standing water that may leave marks in the paint during baking.
去离子水洗后，烘干之前，推荐用一运输链驼峰，至少沥液5分钟，与除去在烘干过程中可在漆面上流下痕迹的水份。