1·The method how the trigger pulse series is generated and shifted is expounded in this paper.
着重剖析了该控制系统产生触发脉冲列与移相的方案；
2·A single trigger pulse generating circuit outputs a pulse signal when an output level of an amplifying unit is changed.
单触发脉冲产生电路在放大单元的输出电平改变的时刻输出脉冲信号。
3·Starting a common trigger pulse, it can measure 64 event time intervals, and never loses them, which belong to simuta-neous events.
它由一个公共触发信号起动变换，可接受64路时间间隔的测量，对于多路同时事件不会造成事件丢失。
4·The high frequency filling each other symmetrical trigger pulse was suggested, which reduce the power need of pulse transformer effectively.
提出采用高频互补对称触发脉冲设计方法，有效地减小了对脉冲变压器的功率要求。
5·Most switch mainframes can be triggered externally via the trigger input and can send an output trigger pulse when the relay contacts have settled.
大多数开关主机都可通过触发输入进行外部触发，并且在继电器触点稳定之后可输出一个触发脉冲。
6·In the developing course, the main technique measures are: improving the trigger circuit of thyristors to eliminate the unsymmetry of the trigger pulse phase;
在研制过程中采取的主要技术措施是：改进晶闸管触发电路，消除了触发脉冲相位的不对称；采用霍尔元件作为电流检测元件，能检测出变压器的实际电流值；
7·Aim at the request of STATOM to the trigger pulse generator, USES CPLD to be high speed, the parallel processing ability, designed the STATCOM pulse generator.
针对STATCOM对触发脉冲发生电路的要求，利用CPLD的高速、并行处理能力，设计了STATCOM的脉冲发生器。
8·The shift trigger pulse of the thyristor trigger circuit with integration amplifier is generated by comparing directly principle of three-phase AC and shift-phase control voltage.
该晶闸管触发器采用集成运数放大器，移相触发脉冲的形成是根据三相交流电的各相与移相控制电压直接比较原理实现的。
9·This instrument has a rotary encoding and raster and it has a special processing circuit not only eliminating trigger pulse case by noise but also clearing up position accumulates error.
柱面散光轴位角进行手动测量，数码显示的数字化屈光度测量仪。本仪器采用特殊的处理电路，消除了外来噪声产生的误触发脉冲及输出错误积累而引起的位置偏移。
10·Applying a negative-going trigger pulse simultaneously to RESET and TRIG during the timing interval discharges C and reinitiates the cycle, commencing on the positive edge of the reset pulse.
应用一个负的触发器脉冲在一个定时周期内来同时复位和触发，这样使电容器C放电并且重新初始化一个循环，从复位脉冲的正边开始启动。