1·Fasteners, the bolt tightening torque of 65 n. M, shall not be destroyed.
采用的扣件，在螺栓拧紧扭力矩达65n . m时，不得发生破坏。
2·Even when loosened by 45 degrees, more than half of the tightening torque remained.
甚至在螺母松脱45度的情况下，其一半以上的锁紧扭矩仍然不变。
3·The equation for calculating minimum tightening torque on the crank pin nut is given.
给出了曲柄销联接螺母的最小拧紧力矩计算公式。
4·Tightening torque is one of the main factors that affect the connection quality in threaded connections.
油套管联接过程中，拧紧扭矩是影响油套管联接质量的主要因素之一。
5·Sensor bolt to be used to ensure a certain degree of tightening torque, prolonged use will not become loose.
传感器要采用螺栓固定，保证一定的紧固力矩，长时间使用不会松动。
6·Always check the assembly drawing for confirmation as tightening torque values on the drawing takes precedence.
始终检查组装图以确认图上的拧紧力矩值优先。
7·This article proposes that the tightening torque design should be made based on the requirements during bolts design.
本文提出在进行螺栓设计时应根据需要或要求对紧固力矩进行设计。
8·It is pointed out the value of tightening torque should guarantee that there is no slippage between cylinder and rasp bar when they work.
脱粒滚筒与纹杆间螺栓联接的扭紧力矩值应按保证工作时滚筒与纹杆间不发生滑移来确定。
9·The value of tightening torque is relative not only to the nominal diameter and quality class of the bolt, but also to the security of the threaded fastener.
指出螺栓联接的扭紧力矩值不仅与螺栓的公称直径及性能等级有关，还与能否保证联接可靠工作有关。
10·Changing the positions of thin and thick nuts and using the right thick nut tightening torque ensure safe operation of the crane and longer lives of the screws.
通过试验和理论分析厚、扁螺母在紧固过程中的受力情况，并从试验结果得到一个较合理的厚螺母拧紧力矩，既能保证塔式起重机的安全运行，又能延长螺栓的使用寿命。