1·It allows users to send and receive data under end to end packet transmission mode.
从而用户能够在端到端分组传送模式下发送和接收数据。
2·Considering the constraints of network bandwidth, multiple-packet transmission was adopted here in the networked control system.
针对网络带宽的限制，在网络控制系统中需要采用多包传输。
3·However, some new issues such as network-induced time delay, network scheduling, multiple-packet transmission and dropping packets also appear.
但由于通讯网络的引入，使得网络化控制系统中存在如网络时延、调度的优化、数据的多包传输及丢失等新问题。
4·The model of NCS with multiple-packet transmission is presented considering system noise and network-induced delay longer than one sampling period.
在考虑系统噪声和网络诱导延时大于一个采样周期的情况下，给出了多包传输的网络控制系统模型。
5·To reduce the computation time of network simulation, a dynamic continuous computing method for the simulation of packet transmission was proposed.
为降低网络模拟的计算开销，提出了数据包转发模拟的动态连续计算方法。
6·At the BS side, an Admission Control Module is added to make admission decision and a Packet Scheduling Module is proposed to schedule packet transmission.
在BS端增加了准入控制模块对业务流进行准入控制，分组调度模块对上下行数据传输进行调度。
7·In all cases, you are looking for a high level of error packets, retransmissions, or dropped packet transmission, all of which indicate that the network is busy.
在所有情况下，都要寻找比较高的错误数据包、重新传输或丢失数据包传输数量，这些都说明网络忙。
8·Exponential stability and controller design problems for networked control system (NCS) with time-varying delay and multiple-packet transmission were studied.
对时变时延多包传输网络控制系统的指数稳定性和控制器设计问题进行研究。
9·We set up a system for packet transmission and transmission control, and propose a layered retransmission error control mechanism based on immediate feedback.
在立即反馈的基础上提出了一种基于分层重传的差错控制机制。
10·The synchronization techniques for burst packet transmission mode OFDM systems is studied, including timing, frequency offset estimation and channel estimation.
本文主要研究适用于突发OFDM传输系统的同步技术，包括定时、频偏估计和信道估计。