1·The image sensor integrates a programmable offset and gain amplifier for each channel of the 32 LVDS outputs.
该图像传感器集成了一个可编程偏移和增益为每32 LVDS输出通道放大器。
2·A new signal processing circuit of vortex flow meter based on variable gain amplifier and digital signal processor (DSP) unit is designed.
设计一种基于变增益运算放大器和DSP数字信号处理单元的新型涡街流量计信号处理电路。
3·Furthermore, a gain value may be sent which may be used to control a variable gain amplifier (VGA) within the transceiver during 8-PSK operation.
而且，可以发送增益值，它可用来控制在8-PSK操作期间的收发信机中的可变增益放大器（VGA）。
4·Three kinds of programmable gain amplifier circuit are introduced in this article. Their applications to electro-acoustic system are introduced, too.
介绍了程控增益放大器三种电路实现方式，以及这几类电路在电声系统中的应用。
5·The measure module has bigger Signal-to-Noise Ratio because adopting instrumentation amplifier, Programmable gain amplifier and accumulate measurement.
信号检测模块采用仪表放大、程控增益放大、积累检测方式等措施有效地提高了测量系统的信噪比。
6·It consists of a variable-gain cell based on a current-steering structure, a novel wide-range exponential voltage generator, and a stage of a fixed-gain amplifier.
该放大器由电流调节型可变增益单元、宽范围指数电压转换电路及固定增益放大器构成。
7·Then after a variable gain amplifier, After A / D conversion and through the microcontroller serial digital data to the ARM within the main control panel for processing.
然后经过一级可变增益放大器，在经过A/D变换，通过单片机串口将数字数据传输到ARM主控制板内进行处理。
8·In this paper we present a design for LD pumped high-gain amplifier system. Factors that have influence on the stability of the structures and method of improvement were fully discussed.
本文通过对LD泵浦高增益放大器系统的结构设计，对影响结构稳定性的因素和作用机理以及提高结构稳定性途径方面进行了较详细的研究。
9·A measurement amplifier circuit is designed, which consists of circuits of differential amplifier, a common-mode rejection, double-end and single-end conversions and programmed gain amplifier.
设计了一个测量放大器电路，它由差动放大电路、共模抑制电路、双端单端转换电路和程控增益放大电路组成。
10·Picoammeter amplifier gain can be changed as in the voltmeter circuit by using the combination shown in Figure 1-11.
和电压表电路一样，可以使用如图1 - 11所示的组合电路来改变皮安表放大器的增益。