1·Such as the charging current is too large.
比如充电电流过大。
2·Therefore, the actual charging current is about 90% of the displayed value.
因此，实际的充电电流大概是显示电流的90%。
3·Notice that as the battery level approaches 100%, the charging current gradually decreases.
要注意的是，随着电池电量达到100%，充电器的电流逐渐减少。
4·Overcharging during the BREAK-IN mode does not harm battery as the charging current is very slow.
在BREAK - IN模式下对电池过充不会对电池造成伤害，因为充电电流非常小。
5·Vref:This is the reference output. It provides charging current for capacitor CT through resistor RT.
这是参考输出。它提供了电容CT充电电流通过电阻RT。
6·The hydrogen embrittlement factor has the same dependence on the hydrogen pressure and charging current density.
合金的氢脆因子与氢气压力或电流密度之间呈相同的依赖关系。
7·The maximum continuous charging current for each output shall be sufficient to charge its battery within 6 hours.
该电池充电器应符合国家的电池标准，并减少其输出到电流充电电池时完全不同。
8·The damage size increases with increase of charging current density, but not so apparent at higher current density.
随电流密度增加，氢损伤尺寸增大，但当电流密度较大时，这种增大不明显。
9·The charging current threshold is modified while the capacitive element is charged to the predetermined charging voltage.
在该电容性元件被充电到该预给定的充电电压期间，该充电电流阈值被改变。
10·It limits the charging current of each capacitor and also protects the relays in case a capacitor becomes short-circuited.
它限制每个电容器的充电电流，并在电容器发生短路时保护继电器。