feedrate
进料速度
常用释义
英音[ ˈfiːdreɪt ]
美音[ ˈfiːdreɪt ]
基本释义
- n. 进料速度；馈送率
例句
-
1·The effect of the feedrate to drilling force is the most significant.进给速度对钻削力的影响最为明显。
-
2·Third, feedrate planning is performed based on the cube fit of turning points.最后对衔接点速度进行三次样条插值处理以生成连续光滑的速度曲线。
-
3·The tool can have an additional 'side-increment' feedrate, which is applied to step-over moves.刀具还可以设置一种边切进给率，以使用于横向的刀具移动。
-
4·Only two parameters can be modified during the real-time control process: feedrate and spindle speed.只有两个参数可以修改，在实时控制过程：进给速度和主轴转速。
-
5·The estimated cutting force and the feedrate are the controlled output and the control input, respectively.估计的切削力和进刀速度分别是受控的输出和控制输入。
-
6·But the contact stability conditions impose some limitations on the impedance control parameters and the feedrate.但是某些联系的稳定性条件的限制控制参数的阻抗和刀具。
-
7·In this paper, effects of depth of cut and feedrate on mechanical properties of metallic fiber are investigated by spinning bit.研究了用自旋转车刀加工金属纤维时，切削深度和进给量对纤维力学性能的影响。
-
8·If the curvature of surface is changeful here and there, the maximum feedrate map must be established to determine the cutting directions.对于曲率变化大的曲面，建立曲面的最优进给方向图，以确定最优走刀方向；
-
9·At the range of the testing parameters it is of advantage to select middle value of feedrate and cutting speed, and smaller value of cutting depth.在本试验参数范围内选取切削参数时，切削速度、进给量取中值有利，切削深度取小值有利。
-
10·The paper develops general interpolation principals for parametric curves with constant feedrate, and contour error's approximate evaluations are discussed also.阐述了参数曲线恒速插补的通用原理，同时讨论了轮廓误差近似计算方法。